Yorumlar için; http://www.bmwteam.net/board/index.php?showtopic=9544

E92 XENON DEĞİŞİMİ

Here are the tools needed:

• 8mm and 10mm socket wrench
• t-20 Torex driver

Make sure u remove the key from ignition and light at off position.

1. Park the car at level place... and remove the front wheel...
2. Start removing screws as i circle them in red.. there are quite alot of them you have to removed.. I took the pic in different angles...

3. More screws to remove under the fender notice that the small rubber piece is secure by 3 screws. 2 in front and 1 behind. There are also few more under the fender not show in the pic.. on the left...

4. Use the t-20 Torex screw driver and remove the 5 screws on the Head light housing...
5. Carefully remove the cover.

6. Unplug the power from the bulb.. by wiggle it and gentally pull it downward.
7. Unhook the 2 clips holding the HID D1S bulb in place.. by carefully push it down and slide them inward..
8. Remove the OEM bulb and replace it with new bulb.
9. Re-secure the bulb with the clips
10. make sure again the power plug is secure plug back in.. as far as it go.. you should able to feel the click it it goes in.
11. start up the enging to make sure the new bulb can be lit up.
12. Remove the key from the car.. to make sure no power goes to HID.
13. Reverse all instruction... and put the fender back in. (Start the fender by the top... slide the top in first.. then when you are very close to fit in the buttom, you will need to slide them in in an angle...)
14. Admire your accomplishment

Stock Xenon w/ Cosmos Blue angel eyes.